Description
Check the specifications, dimensions, variation details, referenced part numbers, and available fitment evidence before matching this item to an application.
NTE Electronics NTE5991 silicon power Rectifier diode, do-5, anode case, 40 amp current rating, 400V
No structured vehicle fitment data is available. Compare the listing with the vehicle and existing part before ordering.
Parameters, dimensions, material, fitment, and part numbers
Buying guidance
Quick decision
A rectifiers listing with source specifications kept visible for comparison.
Fit and size notes
- No structured vehicle fitment was supplied; verify the product details against your application.
Before you buy
- Compare the listing title, photos, package contents, and specifications with the part being replaced.
- Confirm vehicle compatibility and installation requirements before ordering.
Customer feedback
Ratings and written reviews
4.4 / 5
101 source ratings
Source: Amazon. Imported marketplace feedback is shown for product research and is not a review of a purchase made on this website.
David Kent –
I lost two diodes on my automobile battery charger and start booster. One was open and the other one was shorted. Bought two of these, installed them, and now get 80 amps out of the device. I highly recommend these.
Muddy –
Probably solved all my large robot’s motor interference issues. Put it on the ground side for best effect! Acts like a voltage gate.
Douglas H. –
The rectifier worked for a few weeks, and then burned out while being subjected to low voltage (20V) at 30A.Jury is still out, there is bound to be a bad one in every lot.
Greg Gorton –
Used to prevent current flow from one battery to another during use. Worked as it should.
joseph r link –
To protect the electrical system’s of tow vehicles.
Customer –
Perfect replacement for worn selenium disks used for whistle control in Lionel ZW transformers. I own/operate four of such transformers and have installed these in all of them for a total of eight diodes. They are much more reliable than the older technology. Install directly to bracket without insulator bushing. It is a good idea to clean all contacts and inspect rollers at the same time. A few minutes of maintenance will help you get another 70+ years of enjoyment from your ZW!
RJ –
This diode gets very hot even at 25% rated load. Need to use a heat sink with at least 3.5 c/m.
douglas kay –
Nothing