Original price was: $49.99.$47.49Current price is: $47.49.
28 ratingsSource: AmazonUse the specifications, images, available variations, fitment notes, and referenced part numbers to check this product against your application.
Check the specifications, dimensions, variation details, referenced part numbers, and available fitment evidence before matching this item to an application.
Product facts
No structured vehicle fitment data is available. Compare the listing with the vehicle and existing part before ordering.
Customer feedback
Source: Amazon. Imported marketplace feedback is shown for product research and is not a review of a purchase made on this website.
![Auto Ventshade [AVS] Aeroskin Hood Protector | Fits 2014 - 2015 Chevrolet Silverado 1500 | Low Profile Deflector / Bug Shield - 1 pc., Chrome | 622062](https://imaginebroward.org/images/imagesall/images_0/images/I/51c/51cm5Kn-10L._AC_SL500_.jpg)
![Auto Ventshade [AVS] Bugflector II Hood Shield / Protector | Fits 2009 - 2014 Ford F-150 | High Profile Bug Deflector - 1 pc., Dark Smoke | 25940](https://imaginebroward.org/images/imagesall/images_0/images/I/31L/31LykCIgJDL._AC_SL500_.jpg)
J shep –
Fits perfectly on 2024 f150.It looks great and it’s made of a solid thick rubber .Highly recommended 👍
Mack –
Product was not what it appeared , it is a piece of rubber not a moulded hood protector
Ramon Rodriguez –
Looks great, fits great.
Barry F. –
I like the looks of it after I uncoiled it and warmed it up and flattened it, but have not installed it yet, so can’t comment on the finished product.
RazorBacker –
It’s looks to fit well on my 2022 f150 stx but it shows gaps along the bottom as it flares up words the side of the hood.
Mike P. –
It does seem to be just a tad bit longer than the hood, I found off you lay it out for a short time and then lay it on your hood in the sun without sticking down it will lay out and form to the hood better before. Make sure you clean the paint with a cleaner that will clean the wax or polish off it does not stick good on wax or polish.
Dave –
Update 4/6/25The adhesive has failed in the very center and it now has a raised ridge in the middle. It looks like it could be intentional and works to help with water run off. I tried to re secure it with silicone and also with double sided tape. Both did not work. This could be from normal stretching or the product relaxing over time.Original review belowAfter reading the other reviews here about gaps and fitment issues, I did the reverse roll as suggested to flatten it out more from its state it shipped in. Installed mine in cold weather and rain, cleaned and dried the surface before installation. Use a heat gun to warm up the surface as well as the material itself while working the edges down and making sure the double-sided tape adhered properly. No gaps as reported by other reviews, just make sure you line up everything and work middle out once centered. Peeling some of the adhesive on each end to hold in place and repositioning as needed once you get close to the edges.If I have any issues with longevity this review will be updated.
None –
Would not stay on my hood. I think they should use a different wider tape
Billey Evans –
Great product would suggest letting it set in the sun for a lil bit while it is unraveled before putting it on. But great looking and durable.