Description
Check the specifications, dimensions, variation details, referenced part numbers, and available fitment evidence before matching this item to an application.
Vehicle information
Available fitment details
Listing compatibility notes
- 7cm) [Reach Tight Spaces]: Brake fluid cap has a 90-degree coupler that rotates 360 degrees for easier access that fits into tight spaces and prevents your hose from kinking [Quality You Can Trust]: Premium metal and EPDM rubber materials ensure durability and lasting life; Create a tight fit to maintain pressure up to 50PSI (344.
Fitment data is provided as a buying aid. Verify the listing against your vehicle and existing part before ordering.
Parameters, dimensions, material, fitment, and part numbers
Buying guidance
Quick decision
A brake system bleeding tools listing with source specifications kept visible for comparison.
Fit and size notes
- 7cm) [Reach Tight Spaces]: Brake fluid cap has a 90-degree coupler that rotates 360 degrees for easier access that fits into tight spaces and prevents your hose from kinking [Quality You Can Trust]: Premium metal and EPDM rubber materials ensure durability and lasting life; Create a tight fit to maintain pressure up to 50PSI (344.
Before you buy
- Compare the listing title, photos, package contents, and specifications with the part being replaced.
- Confirm vehicle compatibility and installation requirements before ordering.
Customer feedback
Ratings and written reviews
3.8 / 5
35 source ratings
Source: Amazon. Imported marketplace feedback is shown for product research and is not a review of a purchase made on this website.
George Walford –
The only way I can see to hook it up to a compressor is to jury-rig something with a hose clamp. Even then I can’t be sure it won’t pop off.Its a shame, because other than the pressure hook up being this strange connector, the rest of the unit is perfect. Seals all kinds of caps where you might need to pressure them (A gas tank that has been sitting for months to fill the fuel line for example). Fits just fine on Brake master cylinders as well; but good luck coupling it to anything.As it is, I have had to return it because I can’t ensure a positive connection to my air compressor.
Vincent Fuller –
It works as described. It was the only tool that I could find that would some what work to bleed brakes alone on a 1973 Land Cruiser
DG –
This worked great on my existing Schwaben brake bleeder! This definitely fits a wide range of reservoirs. My only complaint is that when only hand tightening the adapter, it was still difficult to remove by hand and I have to use a small wrench to break it loose. Would recommend this if you work on many different makes of cars.
Hayden S –
Much cheaper then competitors but the quality is very good, currently using it on Toyota brake systems connected to a Daytona brand pressure fluid bleeder
Manny R. –
in most of the brake bleeder kits, not all vehicles are covered. This universal adapter will work on almost every one with a round reservoir. it’s pretty much a one size that fits all.
Daniel Poel –
Took a couple of tries to get the seal needed but once I got it the brake job was done in a short time
Ray Breedlove –
Very nicely made unit, but even at the tightest it would go, did not hold anything close to the 50PSI (344.7kPa) described. As soon as I went over 20psi, fluid began leaking not only around the master cylinder reservoir opening, but also back up through the center of the Adapter! Quite a mess! If your bleeding requires only low pressure, then this can be a useful Adapter.
Ben Blass –
I should’ve known that nothing universal fits.The first time I attempted to use this it broke pressure around 5PSI and sent brake fluid everywhere.It’s is a poor quality product with an awful design. Find the correct bleeder cover cap for your car and avoid this product.
James Skiba –
Transaction was great but have not had a chance to use it yet
loc nguyen –
excellent