Description
Check the specifications, dimensions, variation details, referenced part numbers, and available fitment evidence before matching this item to an application.
GM Brass Brake Hose Tee 1 Piece. Brake Hose Tee.This tee is often thrown away with the hose. This tee mounts to the hose. The block slips through the frame bracket and is cliped on the back side of the block. This tee has a size of 7/16-20 to the brake hose, and a slot for the hose clip. No substitution can be made on this part. This solves countless installation problems where the axle lines hook to the original hose. One tee is used per car. This is exact to NOS factory original in every detail except is a brand new inline tube reproduction. Replacement for: 1953- 1967-68 1962-68 1937- 1958-68 1940- 1938-70
No structured vehicle fitment data is available. Compare the listing with the vehicle and existing part before ordering.
Parameters, dimensions, material, fitment, and part numbers
Buying guidance
Quick decision
A fittings listing with source specifications kept visible for comparison.
Fit and size notes
- No structured vehicle fitment was supplied; verify the product details against your application.
Before you buy
- Compare the listing title, photos, package contents, and specifications with the part being replaced.
- Confirm vehicle compatibility and installation requirements before ordering.
Customer feedback
Ratings and written reviews
4.2 / 5
34 source ratings
Source: Amazon. Imported marketplace feedback is shown for product research and is not a review of a purchase made on this website.
Scott B. –
perfect fit
2008_H3_Hummer_#1_DJE –
Thanks perfect fit just what I needed.Well built not cheap junk.
John H. –
Exactly as described and was a true OE, new component.
KEN SEEL –
The product is fine as I expected it to be but the requirement of a lengthy review is too much over the top !
Kira –
Connects rear wheel cylinder brake lines to the brake hose connected to the line that goes to the master cylinder in a 1967 Camaro.Overpriced for what it is, but if you need one, it works.
Customer –
Perfect replacement for my 66
H Pauley –
This was exactly what I needed for our 1960 Chevy C10. It was made exactly like the original, and fit right in the retaining braket precisely.